Engineering Journal: Science and InnovationELECTRONIC SCIENCE AND ENGINEERING PUBLICATION
Certificate of Registration Media number Эл #ФС77-53688 of 17 April 2013. ISSN 2308-6033. DOI 10.18698/2308-6033
  • Русский
  • Английский
Article

The process of enhancement of air-hydrogen mixture combustion in the channel using an air jet

Published: 14.11.2018

Authors: Zamuraev V.P., Kalinina A.P.

Published in issue: #11(83)/2018

DOI: 10.18698/2308-6033-2018-11-1819

Category: Aviation and Rocket-Space Engineering | Chapter: Aerodynamics and Heat Transfer Processes in Aircrafts

The purpose of the study was to carry out the numerical simulation of the launch of  a ramjet using the method without significant loss of total pressure. The method was proposed by the group headed by P.K. Tretyakov. It provides a transition to the transonic condition in the combustion chamber using a jet with a distributed fuel supply along the chamber length. The presence of a jet of compressed air, which creates the throttle effect, is crucial as well as a preliminary flow deceleration to transonic speeds is. In this work, CFD calculations were performed to simulate the flow deceleration to transonic speeds within the framework of the hypothesis of low values of turbulent kinetic energy. The averaged Navier – Stokes equations closed by the k—w SST turbulence model were solved. The combustion of hydrogen was simulated by a single reaction. A pulsating mode was obtained: heat generation during the combustion of hydrogen increases the pressure and blocks its inflow, then the area of increased pressure is carried downstream, a new portion of hydrogen flows in, the process of ignition is in progress, and so on. The critical role in the ignition of hydrogen is played by the shock wave caused by the air stream. Combustion occurs in the zones of separation, vortex zones, the boundary layer. Thus, for the channels under consideration, the possibility of decelerating the flow in a channel with Mach number M = 2 to transonic speeds is numerically shown, which is a favorable prerequisite for implementing combustion in the expanding part of the channel


References
[1] Tretyakov P.K., Zabaykin V.A., Prokhorov A.N. Vysokoskorostnoy PVRD s pulsiruyuschim rezhimom zapuska [High-speed ramjet with pulsating startup mode]. XI Vserossiyskiy sezd po fundamentalnym problemam teoreticheskoy i prikladnoy mehaniki: sbornik dokladov [XI All-Russian Congress on Fundamental Problems of Theoretical and Applied Mechanics: a collection of reports]. Kazan, Kazan University Publ., 2015, pp. 3778–3780. Available at: http://www.itam.nsc.ru/upload/iblock/9f5/01318.pdf
[2] Abashev V. M., Korabelnikov A. V., Kuranov A. L., Tretyakov P. K. Increase in the Efficiency of a High-Speed Ramjet on Hydrocarbon Fuel at the Flying Vehicle Acceleration up to M = 6+. AIP Conference Proceedings 1893, 020005 (2017). DOI: 10.1063/1.5007443
[3] Frolov S.M., Zvegintsev V.I., Ivanov V.S., Aksenov V.S., Shamshin I.O., Vnuchkov D.A., Nalivaychenko D.G., Berlin A. A., Fomin V.M. Doklady Akademii Nauk — Doklady Physical Chemistry, 2017, vol. 474, no. 1, pp. 51–55. DOI: 10.1134/S0012501617050013
[4] Guryleva N.V., Ivankin M.A., Lapinsky D.A., Timoshenko V.I. Uchenye zapiski TsAGI — TsAGI Science Journal, 2012, vol. XLIII, no. 6, pp. 40–54. Available at: http://www.tsagi.ru/institute/publications/memoirs/archive_annotations/2012/%D0%A3%D0%97-6-2012.pdf (accessed November 25, 2017).
[5] Seleznev R.K. Comparison of two-dimensional and quasi-one-dimensional scramjet models by the example of VAG experiment. Journal of Physics: Conference Series, 2017, vol. 815, no. 1, p. 012007. DOI: 10.1088/1742-6596/815/1/012007
[6] O’Brianta S.A., Guptab S.B., Vasua S.S. Review: laser ignition for aerospace propulsion. Propulsion and Power Research, 2016, vol. 5, no. 1, pp. 1–21. DOI: 10.1016/j.jppr.2016.01.004
[7] Firsov A., Savelkin K.V., Yarantsev D.A., Leonov S.B. Plasma-enhanced mixing and flameholding in supersonic flow. Philosophical Transactions: Mathematical, Physical and Engineering Sciences (Series A), 2015, vol. 373, no. 2048, pp. 20140337. DOI: 10.1098/rsta.2014.0337
[8] Firsov A.A., Shurupov M.A., Yarantsev D.A., Leonov S.B. Plasma-assisted combustion in supersonic airflow: optimization of electrical discharge geometry. Paper AIAA-2014-0988. DOI: 10.2514/6.2014-0988
[9] Bezgin L.V., Kopchenov V.I., Starik A.M., et al. Numerical analysis of combustion of a hydrogen-air mixture in an advanced ramjet combustor model during activation of O2 molecules by resonant laser radiation. Combustion explosion and shock waves, 2017, vol. 53, no. 3. pp. 249–261. DOI: 10.7868/S0869565217130114
[10] Zhao Z., Li J.-M., Zheng J., Cui Y.D., Khoo B.C. Study of Shock and Induced Flow Dynamics by Nanosecond Dielectric-barrier-discharge Plasma Actuators. AIAA J. 2015, vol. 53, no. 5, pp. 1336–1348. DOI: 10.2514/1.J053420
[11] Zamuraev V.P., Kalinina A.P. Effect of Surface Energy Pulses on Supersonic Flow in a Channel of Variable Cross Section. Journal of Engineering Physics and Thermophysics, 2016, vol. 89, no. 3, pp. 688–694. DOI: 10.1007/s10891-016-1427-3
[12] Zhuravskaya T.A., Levin V.A. Izvestia RAN. Mekhanika Zhidkosti i gaza — Fluid Dynamics, 2015, no. 2, pp. 117–128.
[13] Wolanski P. Detonative propulsion. Proceedings of the Combustion Institute, 2013, vol. 34, pp. 125–158. DOI: 10.1016/j.proci.2012.10.005
[14] Frolov S.M., Dubrovsky A.V., Ivanov V.S. Khimicheskaya Fizika — Russian Journal of Physical Chemistry B: Focus on Physics, 2012, vol. 31, no. 3. pp. 32–45. Available at: http://www.frolovs.ru/pdf/2012-1-rus.pdf
[15] Liang Jin, Jing Lein, Wei Huang, Zhen-guo Wang. Numerical Investigation on Hydrogen Combustion in a Scramjet with 3D side Wall Compression inlet. Acta Astronautica, 2014, vol. 105, pp. 298–310. DOI: 10.1016/j.actaastro.2014.09.008
[16] Anazadehsayeda A., Barzegar Gerdroodbaryb M., Aminic Y., Moradid R. Mixing Augmentation of Transverse Hydrogen Jet by Injection of Micro Air Jets in Supersonic Crossflow. Acta Astronautica, 2017, vol. 137, pp. 403–414 DOI: 10.1016/j.actaastro.2017.05.007
[17] Barzegar Gerdroodbarya M., Keivan Fallahb, Pourmirzaaghac H. Characteristics of Transverse Hydrogen Jet in Presence of Multi Air Jets Within Scramjet Combustor. Acta Astronautica, 2017, vol. 132, pp. 25–32. DOI: 10.1016/j.actaastro.2016.11.041
[18] Gudich G., Zhukov V.T., Manukovsky K.V., Novikova N.D., Rykov Yu.G., Feodoritova O.B. IPM im. M.V. Keldysha. Preprint — Keldysh Institute Preprints, 2016, no. 10, 32 p. DOI: 10.20948/prepr-2016-10
[19] Seleznev R.K., Surzhikov S.T. Fiziko-himicheskaya kinetika v gazovoy dinamike — Physical-Chemical Kinetics in Gas Dynamics, 2015, vol. 16, no. 3. pp. 1–6. Available at: http://chemphys.edu.ru/issues/2015-16-3/articles/495/ (accessed November 25, 2017).
[20] Zamuraev V.P., Kalinina A.P. Teplovye processy v tehnike — Thermal Processes in Engineering, 2016, vol. 8, no. 7, pp. 292–296.
[21] Zamuraev V.P., Kalinina A.P. Study of the Geometry Effect of the Channel with Variable Cross Section under Forming Transonic Region in the Supersonic Flow with Energy Supply. Journal of Physics: Conference Series, 2017, vol. 894, no. 1, pp. 012118. DOI: 10.1088/1742-6596/894/1/012118
[22] Firsov A.A., Yarantsev D.A., Leonov S.B., Ivanov V.V. Kompyuternye issledovaniya i modelirovanie — Computer Research and Modeling, 2017, vol. 9, no. 1, pp. 75–86. Available at: https://tesis.com.ru/infocenter/downloads/flowvision/fv_es15_11.pdf (accessed November 25, 2017).
[23] Ombrello T., Carter C., McCall J., Kuang-Yu Hsu. Enhanced Mixing in Supersonic Flow Using a Pulse Detonator. Journal of propulsion and power, 2015, vol. 31, no. 2, pp. 654–663. DOI: 10.2514/1.B35316
[24] Cecere D., Giacomazzi E., Ingenito A. A Review on Hydrogen Industrial Aerospace Applications. International journal of hydrogen energy, 2014, vol. 39, pp. 10731–10747. DOI: 10.1016/j.ijhydene.2014.04.126
[25] Yue Liu, Xiaorong Guan, Cheng Xu. A Production Limiter Study of SST-SAS Turbulence Model for Bluff Body Flows. Journal of Wind Engineering & Industrial Aerodynamics, 2017, vol. 170, pp. 162–178. DOI: 10.1016/j.jweia.2017.08.014